FANAR - Полный каталог инструмента для резьбы - 2014 EN PL DE

     H FAflAT  для размещения заказа - fanar@fanar-tools.ru

                                                           TECHNICAL INFORMATION

               Material groups and the range of application

     Group                                            Destination

     800    For carbon constructional steels, free-cutting steels, low -alloy steels w ith tensile strength
            600 MPa < Rm < 800 MPa

     800 Az T yp e 8 0 0 fo r th ro u g h h o le s in s o ft m a te ria ls R m < 5 0 0 M P a

     1300 F o r co n stru ctio n a l steels, alloyed ste e ls w ith te n sile stre n g th 700 M P a < Rm < 1300 M Pa

     INOX F o r h ig h -a llo y steels, sta in le ss and acid re sista n t ste e ls w ith te n sile strength R m < 1000 M P a

     FAN    For tool steels and difficult w orkable steels w ith tensile strength 800 M Pa < Rm < 1200 M Pa
      Ti    and fo r heat-treatable steels up to 38H R C

            F or titanium and th e ir alloys

      Ni F o r n ic k e l a n d th e ir a llo y s
     1400 F o r d iffic u lt w o rk a b le ste e ls, a cid re s is ta n t s te e ls w ith te n s ile stre n g th

                    1000 M Pa < Rm < 1400 M Pa and fo r heat-treatable steels up to 44H R C

     HRC F or hardened steels, num ber next to sym bol indicate m aterial hardness H R C scale
     GG F o r g re y ca st iron and sph e ro id a l ca st iron

     GAL For alum inium alloys Si m ax. 10%
      AL For soft alum inium and soft synthetics

     Ms F o r b rass and sh o rt-ch ip p in g bronze

     S-NC   F or synchro tapping on C N C m achines w ith the function o f "rigid tapping"
      NC    fo r w ide range o f m aterials

            F or productive cutting o f w ide range m aterials, form ing m iddle and long chips
            w ith tensile strenght Rm <1200 M Pa

            Form ing taps fo r m achining m aterials w ith a high adhesion

     WGN F o rm in g ta p s fo r p la s tic m a te ria ls w ith d u c tility A 6> 1 0 %

     WGN Form ing taps fo r m achining m aterials w ith reduced toughness

288

               fanar@fanar-tools.ru www.fanar-tools.ru